I just hooked up the epicenter, but it’s only outputting low muffled noise

  1. Home
  2. Knowledge Base
  3. Troubleshooting Car Audio
  4. I just hooked up the epicenter, but it’s only outputting low muffled noise

This is most likely caused by not sending a full frequency signal to the Epicenter®.

Did you connect the Epicenter to a dedicated sub channel?  If so, this might be your problem.

You need to send a full range signal to the Epicenter in order for it to perform optimally.

For more information on how the Epicenter works, please check out the Knowledge Base article “How does the Epicenter work?”

Was this article helpful?

Related Articles

Pin It on Pinterest