1. Home
  2. Knowledge Base
  3. X series processors / XR series receivers
  4. Control 4 SDDP settings: For X7/X9 processors and XR 4/6/8 receivers.

Control 4 SDDP settings: For X7/X9 processors and XR 4/6/8 receivers.

The AudioControl X series processors and XR series receivers allow Control 4 programmers to enable SDDP (Simple Device Discovery Protocol) for automatic device recognition when setting up a Control 4 system.

On the X series processors and XR series receivers the SDDP function can be enabled by pressing and holding the front panel MENU button for 3 to 4 seconds, this will bring up the Engineering menu on the front panel display. Scroll down to and select the C4 SDDP option and then select ON. Directly below the SDDP setting is the “SEND C4 Identify” option, highlight that option and press select to send.

You can also open the web GUI by entering the IP address of your processor or receiver into a web browser and then navigate to the Engineering tab and set the “Control 4 SDDP” option to ON, then select the SEND button next to the “Control4 Identify” setting.

Was this article helpful?

Related Articles

Submit a Comment

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Need Support?

Can't find the answer you're looking for?
Contact Support

Pin It on Pinterest