print this page
|
email this page
Mobile Audio
Home Theater
Distributed Audio
AudioControl Industrial
Search
sitemap
Find a Dealer
Distributed Audio Amplifiers
HDMI Over Cat-5 / 6
Video Over Cat-5
Audio Over Cat-5
Equalizers
Warranty Registration
New Distributed Audio
Suggestion Box
Support
News
AudioControl Factory
Home
Contact Us
FAQ
Director Model D3200
What is the MAC address of my Director Model D3200?
How can I find my Director Model D3200’s IP address if I enabled DHCP?
Speaker & Wiring Impedance
Why doesn’t the Director Model D3200 recognize the change I made to the IP address?
Do I have to plug the Director Model D3200 into a network?
Bridging The Director
How can I tell why a channel is going into protection?
I want to configure the Director Model D3200 and use all the great features that this amp offers but still want to control the unit with just a 12v trigger, not over Ethernet.
Is an in-wall volume control rated at 60 watts (continuous) adequate?
What happens to the in-wall volume control if the amplifier power is greater than it can handle?
Stacking units of The Director on top of each other without an air space in between.
Daisy-chaining or y-cord audio and power trigger connections?
What are the power requirements and BTU outputs of The Director?
How many units may I put on one 15 amp breaker?
Gain Controls and Level Matching: What is a “Typical” setting for the amplifier gain controls on the rear panel?
What should I use the “Trim” controls in the browser for as compared to the rear panel gain controls
Unique Rooms and SPL in Large Areas: Are there any special considerations for bathrooms?
What about large rooms as well as rooms where the listener is far from the speakers?
HDMI / BVDH-10
HDMI cable is delicate (and expensive), which is why I'm using the BVHD-10 to extend HDMI over CAT-6/5. Do I need to be cautious in how I run my CAT-6/5?
How do I get the best out of my HDMI configuration?
General troubleshooting:
Interoperability:
Source Switching:
HDCP Handshaking:
Status LED Dim or Off:
Sparkles, Snow or Blinking Video:
No Picture:
CAT 5 or CAT 6:
Audio / Video over CAT-5
Balanced Products – using unintended driver/receiver combinations:
How do I wire a BLX-10 to another BLX-10?
How do I send remote power to a BVR-25 from the Maestro M2e?
Is there an advantage to using shielded Cat-5 Wire with AudioControl's Active Balanced Technology?
EIA 568-B Pin-Out Diagram for an RJ-45 Connector?
What is AudioControl's Active Balanced Technology (ABT)?
How far will AudioControl's Active Balanced Technology (ABT) send video and music over Cat-5?
How are AudioControl Active Balanced Technology (ABT) products different from "Baluns"?
Why is the "Made In USA" logo missing from AudioControl product boxes and manuals?
Why should I run CAT-6 instead of CAT-5 Cable?
Whole House Amplifiers
A couple of the zones go into and out of protection even though the in wall volume control are turned down or are rated at twice the power of the Architect Amplifier.
Protection LED is Blue but none of the Channel Status LEDs are on:
Protection LED is Red:
Why Class H?
What is LightDrive?
What is a Programmable Frequency Module (PFM)?
Why is the "Made In USA" logo missing from AudioControl product boxes and manuals?
Why is the "Made In USA" logo missing from AudioControl product boxes and manuals?
HD Sleuth
|
Newsletters
|
Employment Opportunities
|
AudioControl Factory
|
New Industrial
|
FAQ
|
New Distributed Audio
|
News
|
Press Releases
|
FAQ
Distributed Audio Amplifiers
|
Video Over Cat-5
|
Audio Over Cat-5
|
Equalizers