• print this page
  • |
  • email this page
Mobile AudioHome TheaterDistributed AudioAudioControl Industrial
AudioControl®
Search
  • News
  • |
  • Support
  • |
  • sitemap
Mobile Audio
Find a Dealer
  • OEM Integration
  • The Epicenter Processors
  • Pre-Amp Line Drivers
  • In-Dash Car Audio Processors
  • Trunk Mount Equalizers
  • Car Audio Electronic Crossovers
  • Autosound Analyzers
  • Accessories and Remotes
  • System Design Applications
  • Warranty Registration
Suggestion Box
  • Contact Us
  • New Mobile
  • FAQ
  • Home
  • Rialto 400
    • What is the amplifier topology? It's not digital, it's too heavy and sounds too good, and gets too warm… (all good things)Does the headphone amp use the same D/A as the digital inputs, or anotherIf you looked at the Accubass on a spectrum analyzer, what would you see? Wide or narrow boost? How much?Have you looked at any rack mount options?How long does it take to break in?Does the gain control have any affect on the sensitivity of the signal turn on? The sub/mono output on the back, is it just the left signal, or when only one RCA is plugged in, does it sum the channels?If you only connect the digital input (coax or toslink), does it down convert the digital signal to the analogue outputs?
  • What is Dolby Volume technology?
    • What is Dolby Volume technology?
  • Home Theater Amplifiers
    • Why Class H? What Is LightDrive? Why is the "Made In USA" logo missing from AudioControl product boxes and manuals?
  • Home Theater Calibration
    • What is a Room Mode?How can I test for rattles in a home theater?What is "Arrival-time Alignment" and why is it important in home theater?What is level matching and why is it important in home theater?The lights on my AudioControl amplifier aren't bouncing up and down, but my system still sounds fantastic. Is the display broken?
  • BVHD-10/HDMI
    • Which should I use - CAT 5 or CAT 6?Sparkles, Snow or Blinking Video:Status LED Dim or Off:When switching sources, picture may be lost while the source and display or sink boot and negotiate with each other.Interoperability:HDMI cable is delicate (and expensive), which is why I'm using the BVHD-10 to extend HDMI over CAT-6/5. Do I need to be cautious in how I run my CAT-6/5?
  • Active Balanced Technology
    • What is AudioControl's Active Balanced Technology (ABT)?How are AudioControl Active Balanced Technology products different from "Baluns"?How far will AudioControl's Active Balanced Technology send video signals over Cat-5?EIA 568-B Pin-Out Diagram for RJ-45 ConnectorIs there an advantage to using shielded Cat-5 wire?How do I send remote power to the BVR-25 from the Maestro M2e?
  • Technical Papers
    • Home Theater Calibration Guide102 - Crossover Networks from A to Linkwitz-Riley104 - Crossovers and Biamplification105 - How Recordings Are Made106 - Equalizers and Constant-Q107 - Small Room Acoustics De-Mythologized108 - When Was the Last Time You Heard a Perfect Room?
HD Sleuth | Newsletters | Employment Opportunities | AudioControl Factory | New Industrial | FAQ | New Distributed Audio | News | Press Releases | FAQOEM Integration | The Epicenter Processors | In-Dash Car Audio Processors | Trunk Mount Equalizers | Car Audio Electronic Crossovers | Autosound Analyzers | Accessories and Remotes | System Design Applications