Chances are, there is something wrong with your Epicenter® Amplifier if one of these guys are blinking.
Please refer to the cheat sheet below to figure out why
Click to Enlarge
Epicenter 600 product page
Epicenter 1200 product page
- Home
- Knowledge Base
- Troubleshooting Car Audio
- The protection and/or Power LED is flashing on my Epicenter 600/1200
The protection and/or Power LED is flashing on my Epicenter 600/1200
Related Articles
- Three.2 Crossover settings (bypass and normal)
- What to do if you see the “Contact support, need firmware binary” message when trying to open the DM Smart DSP software:
- Failed to load driver error for DM Smart DSP software
- There is no output on the channel 3/sub output on my LC6i/LC7i/LCQ-1
- My AudioControl line converter suddenly will no longer turn on
- My Line out Converter stays on after the car turns off when using the GTO signal sense