- Knowledge Base
- Home FAQ
- What is the minimum voltage needed to trigger Signal Sense on my Architect multi-zone amplifier?
The minimum voltage required is 5 mV.
Was this article helpful?
I want to control your Director amplifier via IP control, what port do I use?
How can I connect headphones to my AVR or Pre-Processor while still having audio play thru the main speakers?
How do I reset my HTR-2 remote to clear out all of the remote codes?
What speaker models are available for the speaker profiles on your new M series zone amplifiers?
How do I access the web interface for my Director Matrix amplifier?
How do I assign a static IP address to my Director Amplifier?